United Security Products AVD-45c Manual descargar pdf (Pagina 85)

1/03 UDC 6300 Process Controller Product Manual 71

Section 4 – Configuration Prompt Definitions

4.1 Overview

Introduction

This section provides information for all the user configurable parameters

listed in the Section 3 - Configuration. If you aren't familiar with these

parameters, this section gives you the parameter prompt, the selection or

range of setting that you can make, and a definition of how each

parameter setting affects controller performance. It will also refer you to

any other prompts that might be affected by your selection.

What’s in this

section?

The table below lists the topics that are covered in this section. They are

listed in the order of their appearance in the controller.

Topic See Page

4.1 Overview 71

4.2 Tuning Parameters Set Up Group 72

4.3 Tuning L2 Parameters Set Up Group 76

4.4 Setpoint Ramp/Rate Set Up Group 77

4.5 Accutune Set Up Group 79

4.6 Algorithm Data Set Up Group 82

4.7 Advanced Math Set Up Group 98

4.8 Output Algorithm Set Up Group 104

4.9 Input 1, 2, 3, or 4 Set Up Group 106

4.10 Input 5 Set Up Group 108

4.11 Control Set Up Group 111

4.12 Control 2 Set Up Group 116

4.13 Options Set Up Group 120

4.14 Communications Set Up Group 128

4.15 Alarms Set Up Group 133

4.16 Display Set Up Group 138

4.17 Calibration Data 141

4.18 Status Test Data 141

ATTENTION

If you are replacing a UDC6000 or an existing UDC6300

you can keep the old configuration data by removing the EEPROM from

the old unit and placing it in the new unit. Refer to Subsection 8.8 for

location of the EEPROM and instructions.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 301 302

Sin comentarios

United Security Products AVD-45c Manual Pagina 85