United Security Products AVD-45c Manual descargar pdf (Pagina 45)

1/03 UDC 6300 Process Controller Product Manual 31

3.4 Configuration Tips

Introduction

Listed below in Table 3-1 are a few tips that will help you enter the

configuration data more quickly.

ATTENTION

If you are replacing a UDC6000 or an existing UDC6300

you can keep the old configuration data by removing the EEPROM from

the old unit and placing it in the new unit. Refer to Subsection 8.8 for

location of the EEPROM and instructions.

Table 3-1 Configuration Tips

Function Tip

Displaying Groups

Use the SET UP

key to display the Set Up groups.

The group titles are listed in this section in the order that

they appear in the controller.

Displaying

Functions

Use the FUNC

key to display the individual

parameters under each group. The prompts are listed in

the order of their appearance in each group.

Scrolling

When in the Set Up mode, use the

or key to scan

the Set Up groups in both directions. Groups scroll at a

rate of 3 per second.

Changing values

quickly

When changing the value of a parameter, you can use a

single

or key. Hold the key in to increase the rate

of change. Stop pressing the key for 1/2 second , then

press again to restart at a slow rate.

You can also adjust a more significant digit in the upper

display by holding in one key

or and pressing the

other

or at the same time.

The adjustment will move one digit to the left.

Press the key again and you will move one more digit to

the left.

Restoring to the

original value

When you change the value or selection of a parameter

while in Set Up mode and decide not to enter it,

press FUNC

and simultaneously, the original value

or selection will be recalled.

Exiting SET UP

mode

To exit Set Up mode, press the LOWR DISP

key.

This returns the display to the same state it was in

immediately preceding entry into the Set Up mode.

Timing out from

Set Up mode

If you are in Set Up mode and do not press any keys for

one minute, the controller will time out and revert to the

mode and display that was being used prior to entry into

Set Up mode and stores any changes you have made.

Key Error

When a key is pressed and the prompt “KEY ERROR”

appears in the lower display, it will be for one of the

following reasons:

• parameter not available

• not in Set Up mode, press SET UP

key first

• key malfunction, do keyboard test (operation)

• Individual key locked out

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 301 302

Comentarios a estos manuales

Sin comentarios

United Security Products AVD-45c Manual Pagina 45

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta United Security Products AVD-45c